Caron 6017 - Manual (Page 65)

6010 Series Operations Manual Rev E 2/14/2012 Page 65 of 68
8. Select the step type by pressing the ADVANCE button.
9. Use the UP and DOWN arrow buttons to define each parameter and the
ADVANCE button to go to the next parameter. The parameters are described
below:
Parameter Description Display
Target set-point Set point for this step t9.SP
Hours Number of hours for a timed step hoUr
Minutes Number of minutes for a timed step Min
Seconds Number of seconds for a timed step SEC
Rate Ramping rate in ºC or %rh per minute rAtE
Wait for process
instance
Instance for wait for process step W.Pi
Wait for process
value
Set-point to wait until reached WPr
Wait Event 1 Event to wait until reached WE.1
Wait Event 2 Event to wait until reached WE.2
Jump Step Step to jump to JS
Jump Count Number of jumps; a 0 indicates an infinite number JC
End Type What controller will do when profile ends End
Off turn control outputs off when profile ends oFF
Hold hold the last set-point when profile ends HoLd
User revert to previous set-point when profile ends USEr
Event Output 1 Whether event 1 is on or off during this step Ent1
Event Output 2 Whether event 2 is on or off during this step Ent2
10. Repeat steps 3 through 9 until the entire profile has been programmed
11. Press and hold the INFINITY button for 2 seconds to exit to home page
12. “Lock” the controller (if desired) by referring to Section 14
For the previous profile example, here is how the entire 7 step program would look like
Parameter Parameter
Display
Variable
Display
Profile 1 FiLE P1
Step 1 P1 1
Timed step type S.tyP ti
Target set-point (20ºC) T9.SP 20
Time in hours hoUr 0
Time in minutes Min 0
Time in seconds SEC 0