MTS Series 793 User Manual
Page 146
Advertising
Description
Item
Sets the ramp time from run to hold states. Applies to
procedures where the MPT application’s Option Editor
Hold
window Command Hold Behavior selection is either Ramp
to Mean or Ramp to Zero.
Sets the ramp time from hold to run states. Applies in
procedures where the MPT application’s Option Editor
Resume
window Command Hold Behavior selection is either Ramp
to Mean or Ramp to Zero.
Item
Callout
Command Amplitude
1
Current Setpoint
2
Start/Resume Ramp Time
3
Waveform ramping from the current setpoint to the Target
Setpoint.
4
Target Setpoint
5
146 MTS Series 793 Control Software
Station Manager Application
Advertising