MTS Series 793 - Manual (Page 434)

Description Item CAllout
Provides quick access to frequently used commands
and displays. Toolbar 1
Displays the name of the currently opened test. Test Name
Displays the name of the data file currently in use. Data File
Provides controls to set up a test command. After
the initial command is defined, you can adjust the Test Command Controls 2
slider controls on the display while the test is running
as follows:
• For cyclic commands you can adjust the target
setpoint, amplitude, and frequency.
• For monotonic commands you can adjust the end
level and ramp time.
Allows you to select the required wave shape for the
test command. Wave Shape
When multiple channels are enabled, only the
compensators available on all enabled channels will
be available in this list. Compensator
Allows you to activate a compensator for the test
command.
Establishes a preset count that can be repeated,
while maintaining two counters that monitor the
current count and the total count for the test. Test Counters 3
Monitors the detector actions you have set for a
channel. Indicator colors are as follows: Peak Detectors 4
• Grey indicates that all detectors are set to
Disabled.
• Green indicates that all enabled detectors are set
to Station Power Off, Interlock, Program Interlock,
Program Stop, Program Hold, or Custom Actions.
• White indicates that one or more detectors are
set to Indicate.
• Red indicates that a detector has been tripped.
The reset button
clears the detector action after the detector trips
Click the Return Home button to return your actuators
to a default or starting position. This button is not
available while a test is running. Return Home button 5
434 MTS Series 793 Control Software
Basic TestWare Application