Rockwell Automation 1305 AC Drive, Series C, Firmware 6.xx and Up - Manual (Page 75)

Programming 5-7
Metering Group (continued)
[Drive Temp] Parameter # 70 Factory Default None [Drive Temp]
Parameter Type Read Only Minimum 0
This parameter displays the drive internal temperature. Units 1 _C Maximum 100 _C
[Last Fault] Parameter # 4 Factory Default None [Last Fault]
Parameter Type Read Only Minimum 0
This parameter displays the fault code for the present drive
fault. If there is no active fault, the value will be zero. Units Numeric Maximum Max. Fault Number
[% Output Power] Parameter # 3 Factory Default None [% Output Power]
Parameter Type Read Only Minimum 0 %
This parameter displays the percent of drive rated output
power. Units 1 % Maximum 200% Drive Rated
Power
[% Output Curr] Parameter # 2 Factory Default None [% Output Curr]
Parameter Type Read Only Minimum 0 %
This parameter displays the percent of drive rated output
current. Units 1 % Maximum 200% of Rated Drive
Output Current