Rockwell Automation 1412-PP21xx PowerPad Portable Powermonitor - Manual (Page 13)

Rockwell Automation Publication 1412-UM001D-EN-P - September 2012 13
Product Features Chapter 1
Battery Charge Status
TIP Protocol:
U - Signifies phase-to-phase voltage
V - Signifies phase-to-neutral voltage
L1, L2, L3 - Refer to the phases (A, B, C, or other)
Battery Status Battery Indicator Power Cord
Battery Charging
·Battery capacity level relative to full charge
·% of total capacity already charged (between 0 and 99%)
·Battery sign and % are blinking
Line cord is plugged in.
Battery Full
·Battery sign and % are fixed
·% of total capacity is at 100%
Line cord may or may not 100% be plugged in.
Battery Discharging
·Battery capacity level relative to full charge
·% of the remaining capacity
·Battery sign and % are fixed
Line cord is not plugged in.
Battery Empty Discharging
·% of total capacity reads 0%
·Battery sign and % are fixed
Line cord is not plugged in.
New Battery Charging
·Fixed battery capacity level
·Question mark showing unknown capacity level
·Battery sign and % are blinking
Line cord is plugged in.
New Battery Discharging
·Fixed battery capacity level
·Question mark showing unknown capacity level
·Battery sign and % are fixed
Line cord is not plugged in
25%
100%
25%
0%
?
?
WARNING: The battery may fully discharge when recording for long periods of
time while not connected to a power supply. The PowerPad unit will continue to
record for some time, even if below the minimum battery charge value.
However, the display may not come back on, and will eventually stop saving
data when the battery is too low. All data recorded will be saved.
If in the Record Mode, and the display does not come ON, do not turn the
instrument OFF. Supply power to the PowerPad unit with the line cord and the
display will come back ON when any button (other than ON/OFF) is pressed.
TIP When the PowerPad unit is stopped by using the On/Off button, a confirmation
is requested if the equipment is in the process of recording.