Rockwell Automation 1412-PP21xx PowerPad Portable Powermonitor - Manual (Page 69)

Rockwell Automation Publication 1412-UM001D-EN-P - September 2012 69
Chapter
5
Maintenance
Use only factory specified replacement parts. Rockwell Automation is not held
responsible for any accident, incident, or malfunction following a repair done
other than by its service center or by an approved repair center.
Recharging and Changing
the Battery
The battery is automatically charged when the unit is connected to AC power.
Cleaning
• Use a soft cloth, lightly dampened with soapy water
• Wipe with a damp cloth and then dry with a dry cloth
• Do not splash water directly on the clamp
• Do not use alcohol, solvents or hydrocarbons
WARNING:
· When changing the battery, it must be de-energized, the
equipment turned off, and there must be a delay of at least one
minute without the battery being connected.
· Do not expose the battery to heat exceeding
100 °C (212 °F).
• Do not short-circuit the battery terminals.
IMPORTANT Disconnect the instrument from any source of electricity.