Rockwell Automation 1305 AC Drive, Firmware 1.01-3.00 User Manual - Manual (Page 157)

Index
I-1
A
AC Input Wiring, 2-11
Accel/Decel Control, 5-8, 5-9, 5-25,
5-27, 5-28
Accessories, C-1
Adapters, 2-20
Ambient Temperature, A-3
Analog Input
0-10V, 2-17, A-3
4-20mA, 2-17, 5-21, A-3
Analog Invert, 5-21
Analog Output, 2-17, 5-35, A-4
Auto Restart, 5-30
B
Block Diagram, A-1
Brake, 5-11, 5-23, B-6, B-12, B-13
C
Cable Termination, 2-19
Carrier Frequency, 5-20, A-4
Catalog Number Description, 1-5
Choose Mode, 3-5, 3-6
Clearing Faults, 5-36, 5-37, 6-1
Control Panel
Analog Speed Potentiometer, 3-3
Direction Indicators (LEDs), 3-3
Speed Indicator, 3-3
Control Panel Keys
Change Direction, 3-3
Increment/Decrement, 3-3
Jog, 3-2
Start, 3-2
Stop, 3-2
Control Status Mode, 3-5, 3-14
Conventions Used in Manual, 1-3
Current Limiting, 5-12, 5-13, 5-36
Current Rating, 1-5
Custom Volts/Hertz Patterns, 5-16, 5-17, 5-18
D
DC Brake to Stop, 5-11, 5-23
DC Hold Level, 5-23
Diagnostics Group, 5-38
Dimensions, 2-2
Display Mode, 3-5, 3-7
Display Panel Keys
Enter, 3-2
Escape, 3-2
Increment/Decrement, 3-2
Select, 3-2
Distances between Devices, 2-1, 2-21
Drive Temperature, 5-7, 5-42
Dynamic Brake, 2-11
E
EEProm Mode, 3-5, 3-10
Drive––>HIM, 3-11
HIM––>Drive, 3-12
Electrical Interference, 2-7
Enable Signal, 2-17
ESD, Electrostatic Discharge, 1-1
F
Fan/Pump Volts/Hz Patterns, 5-18
Fault Buffer History, 5-36
Faults
Diag C Lim Fault, 6-3, 6-4
Drive Reset Fault, 6-3
EEprom Fault, 6-3
Hertz Err Fault, 6-3
Hertz Set Fault, 6-3
IPM Current Fault, 6-4
IPM Overtemp Fault, 6-4
Max Retries Fault, 6-4
Motor Mode Fault, 6-5
Motor Stall Fault, 6-5
Neg Slope Fault, 6-5
Op Error Fault, 6-5, 6-6
Open Pot Fault, 6-6
Overcurrent Fault, 6-6
Overload Fault, 6-6
Overspeed Fault, 6-6
Overtemp Fault, 6-6
Overvolt Fault, 6-6
Phase U Fault, 6-7
Phase V Fault, 6-7
Phase W Fault, 6-7
Power Loss Fault, 6-7
Power Mode Fault, 6-7
Reprogram Fault, 6-7
Run Boost Fault, 6-7
Serial Fault, 6-8