Rockwell Automation 1305 AC Drive, Firmware 1.01-3.00 User Manual - Manual (Page 19)

LED
Fault
Indicator
TB2 - Control Terminal Block
Hinged Panel
TB1 - Power Terminal
Block
DC Bus Charge Indicator
Retaining Lever
Human Interface Module
(See back for Series Letter and
Firmware Revision Level)
Firmware
Revision
Level
Number
Serial
Number
ATTENTION: Proceed with caution. A DC Bus
Voltage may be present at the Power Terminal
Block (TB1) even when power is removed from
the drive.
Chapter 2 – Installation/Wiring
2-3
TERMINAL BLOCK ACCESS
To access the power and control terminal
blocks, perform the following procedure:
1. Remove power from the drive.
2. Lower the hinged panel located below the
HIM or blank front panel.
3. For drives equipped with a blank front
panel, slide the panel downward and
remove from the drive. Skip to Step 5.
4. For drives equipped with a HIM, press the
retaining lever directly beneath the HIM
and slide the HIM downward to remove
from drive.
5. Remove the front cover by grasping the
upper corners of the cover and pulling the
cover to a 90
°
angle to the drive. Lift the
cover off.
Figure 2.3 Terminal Block Access