Rockwell Automation 1305 AC Drive, Firmware 1.01-3.00 User Manual - Manual (Page 74)

Chapter 5 – Programming
5-6
Metering Group (cont.)
[Output Freq] Parameter # 66 Factory Default None [Output Freq]
Parameter Type Read Only Minimum – [Maximum Freq]
This parameter displays the output frequency present at
TB1, terminals T1, T2 & T3 (U, V & W). Units 0.01 Hz Maximum + [Maximum Freq]
[Freq Command] Parameter # 65 Factory Default 0.00 Hz [Freq Command]
Parameter Type Read Only Minimum 0.00 Hz
This parameter displays the frequency that the drive is
commanded to output. This command may come from any
one of the frequency sources selected by [Freq Select 1],
[Freq Select 2] or [Preset Freq 1-7] the preset speeds 1-7
as determined by the inputs to SW1, SW2, and SW3 at
TB2. Units 0.01 Hz Maximum +400.00 Hz
[MOP Hz] Parameter # 42 Factory Default None [MOP Hz]
Parameter Type Read Only Minimum 0.00 Hz
This parameter displays the frequency reference
commanded by the MOP function through serial
communication. This value is displayed regardless of
whether or not this is the active frequency command. Units 0.01 Hz Maximum 400.00 Hz