Module installation and removal – Rockwell Automation 1746-INT4 Thermocouple/MV Isolated/ User Manual User Manual
Page 27
Publication 1746-UM614B-EN-P - September 2007
Install and Wire the Module 27
Module Installation and
Removal
When installing the module in a chassis, it is not necessary to remove
the terminal block from the module. However, if the terminal block is
removed, use the write-on label located on the side of the terminal
block to identify the module location and type.
Write-on Label
IMPORTANT
Some analog I/O modules, such as the 1746-FIO4I, 1746-FIO4V,
1746-NO4I, and 1746-NO4V, may require an additional 24V dc
power supply. For those modules, as needed, refer to the user
manual.
50
100
150
200
(0, 180)
50
100
150
200
250
300
350
400
450
(255, 180)
24V dc Current (mA)
(455, 0)
5V dc
Current
(mA)
(295)
(85)
(295, 85)
x
Module
5V dc
24V dc
OA8
INT4
0.185
0.110
0
0.085
Total
0.295
0.085
SLOT ____ RACK ____
•
MODULE _______________