Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 2)

Important User Information
Because of the variety of uses for the products described in this
publication, those responsible for the application and use of this
control equipment must satisfy themselves that all necessary
steps have been taken to assure that each application and use
meets all performance and safety requirements, including any
applicable laws, regulations, codes and standards.
The illustrations, charts, sample programs and layout examples
shown in this guide are intended solely for purposes of example.
Since there are many variables and requirements associated with
any particular installation, Allen-Bradley does not assume
responsibility or liability (to include intellectual property
liability) for actual use based upon the examples shown in this
publication.
Allen-Bradley publication SGI-1.1, Safety Guidelines for the
Application, Installation and Maintenance of Solid-State Control
(available from your local Allen-Bradley office), describes some
important differences between solid-state equipment and
electromechanical devices that should be taken into consideration
when applying products such as those described in this
publication.
Reproduction of the contents of this copyrighted publication, in
whole or part, without written permission of Allen-Bradley
Company, Inc., is prohibited.
Throughout this manual we use notes to make you aware of safety
considerations:
Attention statements help you to:
• identify a hazard
• avoid a hazard
• recognize the consequences
!
ATTENTION: Identifies information about
practices or circumstances that can lead to personal
injury or death, property damage or economic loss.
Important: Identifies information that is critical for successful
application and understanding of the product.
PLC, PLC2, PLC3, and PLC5 are registered trademarks of Rockwell Automation.
SLC, SLC500, PanelView, RediPANEL, and Dataliner are trademarks of Rockwell
Automation.
IBM is a registered trademark of International Business Machines, Inc.