Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 52)

6-2 Quick Recall Functions
Publication 1747-6.1
7. The display then returns to the previous address display:
8. You may now perform any of the module functions.
Using Quick Recall
Functions
After defining the Quick Recall Function, you are able to recall that
data file address at any time. The module may be configured for the
Modify or Monitor modes.
In the Monitor mode, if the unit has been configured with the
Monitor Override feature set to On, you can modify data at that data
file address by recalling the Quick Recall Function.
1. Make sure the module is attached to a processor.
2. To recall Quick Recall Function F(1), from any screen:
Press >) @ >@
3. The module displays the data file address assigned to that Quick
Recall Function:
4. You are now able to view or alter the data at this data file address
using the procedures described in the previous chapter.
T4:1.ACC
9999
Important: If the unit is connected to a DH485 Network, the
module is able to communicate with multiple
processors on the network. Any data file address
assigned to a Quick Recall Function and stored in the
module’s nonvolatile memory is accessible in any
processor data file on the network to which the module
is attached.
Important: Data can be modified in the Monitor mode with the
Monitor Override set to On only at the address
displayed by a Quick Recall Function. Addresses
displayed using the
>1(;7@ >35(9@ >,1&@
or
>'(&@ keys can be monitored but not modified in this
mode.
T4:1.ACC
9999