Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 46)

5-12 Monitoring and Modifying Data
Publication 1747-6.1
How to Display Different Bit File Addresses
To increment the Bit address from B10:7/13:
Press >,1&@
The next highest bit address in that word displays along with its
associated on/off state:
The [ '(& ] key decrements addresses in the same fashion.
If the highest bit address in the element is displayed and the [
,1&
] key
is pressed, the display rolls over to display the lowest bit address in
that element. The [
'(& ] key works in the same fashion.
How to Change Data
File Values
Once you have the desired data file address displayed on the module,
you may change the value stored there, change the sign of an Integer
value, or change the on/off status of individual bits.
How to Change Word Values
You can change the value of a displayed word by using the [ ,1& ] and
[ '(& ] keys or by entering new values, using the numeric keys.
You may use the [ ,1& ] and [ '(& ] keys to change values stored at data
file word addresses.
1. To increment the value stored at T4:3.PRE:
Press [ ,1& ].
2. The LCD displays the new value in the lower right-hand corner
and the previous value in the lower left-hand corner:
3. You may continue pressing the [ ,1& ] or [ '(& ] keys until the
appropriate value is displayed, then:
Press [
(17(5 ].
B10:7/13
. . 1 . . . . . . . . . . . . . . . . .
T4:3.PRE
25
T4:3.PRE
26 25