Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 57)

Processor Control Functions 7-3
Publication 1747-6.1
Clearing Processor
Faults
The module must be configured for the Modify mode to clear
recoverable faults in the attached processor.
1. You may first choose to view a fault condition as described in the
previous section.
2. To clear a fault, initiate the Clear Fault procedure from any
screen:
Press
>) @ >6+,)7@ >7@
3. If the DTAM is not attached to a 5/03 with the keyswitch in
RUN, the fault clears, and the processor is placed in the Program
mode.
4. The Ready Attached screen displays:
5. You may now return the processor to the Run mode or initiate
other module functions.
For additional information on faults and fault codes refer to chapter 9,
Troubleshooting.
!
ATTENTION: If the DTAM is attached to a 5/03 and
the processor keyswitch is in the RUN position when
you start to clear the fault, the processor enters the
RUN mode once the fault is cleared.
RDY> 4 RHALT
5/02 1111
Important: Before trying to place the processor in the Run mode,
you must ensure that the cause of the fault has been
corrected. If it is not rectified, the processor returns to
the faulted condition as soon as you attempt to place it
in Run mode.