Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 26)

3-4 Module Setup Procedure
Publication 1747-6.1
Selecting the
Language
You can configure the module to display all prompts and data in one
of six languages. The available languages are: English, Spanish,
Japanese, Italian, German and French. The default language
displayed is English:
• To change the language displayed:
Press >,1&@ or >'(&@
• To accept the displayed language:
Press >(17(5@
Once you have selected a language, the module immediately begins to
display in that language.
Selecting the Node
Address
The node address is the communications identifier on the DH485
network for this module. Valid node addresses range from 0 through
31. The default node address displayed is 0.
• To change the node address:
Press [ ,1& ] or [ '(& ].
• To accept the displayed address:
Press >(17(5@
Select Language
ENGLISH
Important: Care must be taken when selecting a node address. Do
not duplicate the address of a processor or another
device on the DH485 network.
Select DTAM Addr
0