Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 55)

Publication 1747-6.1
Chapter
7
Processor Control Functions
This chapter describes the procedures to:
• change processor modes
• view and clear processor faults
• transfer user programs between RAM and EEPROM memory
Changing the
Processor to Run
Mode
The module must be configured for the Modify mode to change the
processor to Run mode. If the module is attached to a 5/03 processor,
the keyswitch must also be in the REM position to change the
processor mode.
When the module is attached to a processor, the module displays the
Ready Attached screen with the processor operating mode displayed
in the upper right-hand corner:
1. To place the attached processor into the Run mode from any
screen where data is not being entered:
Press
>) @ >6+,)7@ >2@
2. The module displays:
3. To confirm:
Press >(17(5@
4. The processor enters the Run mode and the module displays:
RDY> 4 RHALT
5/02 1111
Confirm?
Enter RUN,