Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 91)

Troubleshooting 9-11
Publication 1747-6.1
Troubleshooting
Processor Faults
Using the LCD
If you are attached to a processor when a fault occurs, the module
displays a fault code, in hexadecimal format, and a description of the
fault. You may also attach to a faulted processor to view the source of
a fault. The tables below describe the possible fault conditions in SLC
500 family processors.
The characters xx in the following codes represent the slot number, in
hex. The characters xx become 1F if the exact slot can not be
determined.
Slot Numbers in Hexadecimal
Slot XX Slot XX Slot XX
0 00 11 0B 22 16
1 01 12 0C 23 17
2 02 13 0D 24 18
3 03 14 0E 25 19
4 04 15 0F 26 1A
5 05 16 10 27 1B
6 06 17 11 28 1C
7 07 18 12 29 1D
8 08 19 13 30 1E
9 09 20 14
10 0A 21 15
PROCESSOR ERRORS
Error
Code
Module Display Fault Description
0000 NO FAULT
You have attempted to view a fault in a non-
faulted processor.
0001 CORRUPT NVRAM NVRAM error.
0002 HARDWARE TIMEOUT Unexpected hardware watchdog timeout.
0003 AUTOLOAD FAILED
Memory module memory error. This error can
also occur when going to the REM Run mode.
0007
1
1. Error codes for 5/03 processor only
TRANSFER FAILED
Failure during memory module transfer of
autoload.
0008
1
CPU SOFTWARE ERR Internal software error.
0009
1
CPU HARDWARE ERR Internal hardware error.
0010 WRONG PROC. REV.
The processor does not meet the proper revision
level.
0011 FILE 2 MISSING The executable program file number 2 is absent.
0012 PROG MEM. ERROR The ladder program has a memory error.
0013 MEM MOD MISSING
The required memory module is absent or either
S:1/10 or S:1/11 is not set as required by the
program.
0014 INT. FILE ERROR Internal file error.
0015 CFG. FILE ERROR Configuration file error.