Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 27)

Module Setup Procedure 3-5
Publication 1747-6.1
Setting the Baud Rate
This is the communications rate for the module. Available baud rates
are: 1200, 2400, 9600 and 19200 baud. The default baud rate
displayed is 19200.
• To scroll through the available baud rates:
Press [ ,1& ] or [ '(& ].
• To accept the displayed baud rate:
Press [ (17(5 ].
Setting the Auto
Attach Function
This selection determines how the module attaches to a processor.
The default selection is Off.
When the function is set to Off, you are required to manually attach to
a processor each time the module is powered up.
When the function is set to On, the module attempts to attach to the
address of the last processor it was logically attached to or to the
default node address of one.
• To toggle between On and Off:
Press [ ,1& ] or [ '(& ].
• To accept the setting:
Press [ (17(5 ].
Important: All devices on the DH485 network, including the
module, must be set to the same baud rate.
Select Baud Rate
19200
Set Auto Attach
OFF