Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 33)

Attaching to a Processor 4-3
Publication 1747-6.1
Ready Attached
Screen
The Ready Attached screen displays the ready prompt, processor
node address, and processor operating mode on the top line, and the
processor type and program name on the bottom line:
Operating Mode Text
The text displayed in the Ready Attached screen depends on the
processor mode and type, as summarized in the table below.
Backspace Function
During Attach
Procedure
If you incorrectly entered the node address during the Attach
procedure (and have not pressed [
(17(5 ] yet), you can use the
Backspace Function to delete characters from right to left, and then
re-type the value. Backspacing to the beginning of the string (leftmost
character) will in most cases return the default value. The exception is
during password entry.
There are two ways to implement the Backspace Function:
• Single Backspace - Press and release the [ 6+,)7 ] key, then press
and release the [ (6& ] key.
• Multiple Backspace - Press and hold the [ 6+,)7 ] key while
repeatedly pressing the [ (6& ] key.
The example below shows a default node address of 15.
If you press 3 then 0, the node address changes to 30, as shown below.
RDY> 4 RRUN
5/02 4444
Processor Mode Operating Mode Text
SLC 500, SLC 5/01 ™
and
SLC 5/02 ™ Processors
and
SLC 5/03 and SLC 5/04
processors with
Keyswitch in REM
SLC 5/03 or later
processors with Keyswitch
Not in REM
Run RRUN RUN
Program RHALT HALT
Test RTEST HALT
Fault FAULT FAULT
Attach to CPU?
15
Attach to CPU?
30