Rockwell Automation 2711P PanelView Plus Terminal User Manual - Manual (Page 129)

Publication 2711P-UM001J-EN-P - November 2009 129
Windows CE .NET Operating System Chapter 5
Multi-Key Lockout
Under Multi-Key Lockout, select one of the following options:
•
Enabled - any programmable key that is pressed inhibits all keys
until the programmable key is pressed again. This includes the
Alt, Ctrl, and Shift keys.
•
Enabled with Abort - any secondary key press will terminate the
initial key press immediately.
•
Disable - places no restrictions on key presses. Clear both
checkboxes.
Hold-Off Delay
If enabled, this option will ignore multiple presses of the same key for
a specified length of time. To enable this option, select the Enable
Hold-Off mode checkbox. Then adjust the delay time by moving the
slider to the left or right to increase or decrease the hold off time.
Mouse
If a mouse is attached to one of the USB ports of the PanelView Plus
CE terminal, you can set the sensitivity for both the speed and
physical distance between mouse taps. Double-tap the top grid to set
the sensitivity. Double-tap the bottom grid to test the setting. Click
OK.
Input Panel
The Input Panel dialog sets properties for the soft Keyboard input
panel. Use the Options button to select Large or Small keys, and other
soft key options. Click OK after making any changes.
IMPORTANT
The keypad cannot produce Home, End, Page Up, or Page Down
when Multi-Key Lockout is enabled.