Rockwell Automation 2711P PanelView Plus Terminal User Manual - Manual (Page 220)

220 Publication 2711P-UM001JEN-P - November 2009
Chapter 9 Troubleshoot the System
•
Check the event log in the Hardware Monitor control panel
application or under Terminal Settings>System Event Log in
Configuration mode. Look for error conditions or reasons for
unexpected reboots.
•
Check the configuration settings in the PanelView Plus CE
control panel applications or terminal Configuration mode.
System Identification Errors The error messages in this section appear on startup if incorrect or
invalid components are used with the 700 to 1500 terminals.
•
This dialog appears if a PanelView Plus CE logic module is
attached to a PanelView display module. We recommend that
you use a PanelView Plus CE display module with a PanelView
Plus CE logic module. This is a warning letting you continue to
operate.
•
This dialog appears if the PanelView Plus logic module contains
a 2711P-RWx internal CompactFlash card for the PanelView Plus
CE terminal.
After pressing OK, you will be asked to power off the terminal
and insert a valid 2711P-RWx internal CompactFlash card for the
PanelView Plus terminal.
•
This dialog appears if the PanelView Plus CE logic module
contains a 2711P-RWx internal CompactFlash card for the
PanelView Plus terminal.
TIP
Terminals manufactured after January 2007 switch displays
without displaying the following error messages.
(6189-RWX)