700 to 1500 terminals – Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual User Manual
Page 131
Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013
131
Install and Replace Components
Chapter 5
3. Lift up on the cover.
4. Remove the battery.
5. Insert the new battery with the positive (+) polarity facing up and press
gently until the battery snaps into place.
6. Close the battery cover and push the end in until you hear a click.
700 to 1500 Terminals
Follow these steps to replace the battery.
1. Disconnect power from the terminal.
2. Place the terminal, display side down, on a flat stable surface.
3. Detach the communication module, if attached, from the logic module by
removing the four screws.
4. Loosen the four captive screws that attach the logic module to the display.
CR2032
Communication Module
Display Module
Captive Screw
Screw
Logic Module