Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual - Manual (Page 27)

Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013 27
Chapter
2
Install Terminal
Topic Page
Required Circuit Parameters for USB Peripheral Devices 29
Mounting Clearances 30
Panel Guidelines 30
Panel Cutout Dimensions 30
Remove and Install the Power Terminal Block 37
Mount the 400/600 Terminal in a Panel 33
Mount the 700 to 1500 Terminal in a Panel 35
Remove and Install the Power Terminal Block 37
DC Power Connections 38
AC Power Connections 41
Initial Startup 43
Reset the Terminal 43
ATTENTION: Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II applications (as defined
in IEC 60664-1), at altitudes up to 2000 m (6561 ft) without derating.
The terminals are intended for use with programmable logic controllers. Terminals that are AC powered must be connected to the
secondary of an isolating transformer.
This equipment is considered Group 1, Class A industrial equipment according to IEC CISPR 11. Without appropriate precautions, there
may be difficulties with electromagnetic compatibility in residential and other environments due to conducted or radiated
disturbances.
Korean Radio Wave Suitability Registration - When so marked this equipment is registered for Electromagnetic Conformity
Registration as business equipment (A), not home equipment. Sellers or users are required to take caution in this regard.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from
accessibility to live parts. The interior of the enclosure must be accessible only by the use of a tool. The terminals meet specified
NEMA, UL type, and IEC ratings only when mounted in a panel or enclosure with the equivalent rating. Subsequent sections of this
publication may contain additional information regarding specific enclosure type ratings that are required to comply with certain
product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, publication 1770-4.1 , for additional installation requirements
• NEMA Standards 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by different
types of enclosure