Rockwell Automation 2711P-xxxx PanelView Plus 6 Terminals User Manual - Manual (Page 53)

Rockwell Automation Publication 2711P-UM006C-EN-P - April 2013 53
Configuration Mode Chapter 3
Run the Loaded Application on Startup
Follow these steps to run the FactoryTalk View .mer application currently loaded
in the terminal on startup. This is typical when running a closed system.
1. Press Terminal Settings>Startup Options.
2. Press On Startup to select Run Current Application.
If an application is not loaded, the options are disabled.
3. Press Replace RSLinx Enterprise Communications to specify what
configuration settings to use when running the application:
• Select No to use the RSLinx configuration of the terminal.
• Select Yes to use the configuration of the application. The terminal
configuration is replaced with the application settings. Any changes to
device addresses or driver properties in RSLinx communication are lost.
4. Press Delete Log Files On Every Power Cycle to specify what action to take
with the log files on startup:
• Select Yes to delete all log files (data, alarm history, alarm status)
generated by the terminal before running application. The files are
deleted from the system default location.
• Select No to retain all log files.
5. Press OK twice to return to Terminal Settings.