Rockwell Automation 1440-SPD02-01RB XM-220 Dual Speed Module - Manual (Page 11)

Publication GMSI10-UM004B-EN-P - May 2010
Introduction 3
• XM-220 Dual Speed Module - Mounts on the XM-941 terminal base
unit via a keyswitch and a 96-pin connector. The XM-220 contains the
measurement electronics, processor, relay, and serial interface port for
local configuration.
Using this Manual This manual introduces you to the XM-220 Dual Speed module. It is intended
for anyone who installs, configures, or uses the XM-220 Dual Speed Module.
Organization
To help you navigate through this manual, it is organized in chapters based on
these tasks and topics.
Chapter 1 “Introduction” contains an overview of this manual and the
XM-220 module.
Chapter 2 “Installing the XM-220 Dual Speed Module” describes how to
install, wire, and use the XM-220 module.
Chapter 3 “Configuration Parameters” provides a complete listing and
description of the XM-220 parameters. The parameters can be viewed and
edited using the XM Serial Configuration Utility software and a personal
computer.
Appendix A “Specifications” lists the technical specifications for the XM-220
module.
Appendix B “DeviceNet Information” provides information to help you
configure the XM-220 over a DeviceNet network.
Appendix C “DeviceNet Objects” provides information on the DeviceNet
objects supported by the XM-220 module.
For definitions of terms used in this Guide, see the Glossary at the end of the
Guide.
IMPORTANT
The XM-441 Expansion Relay module may be connected
to the XM-220 module via the XM-941 terminal base unit.
When connected to the XM-220, the Expansion Relay
module simply “expands” the capability of the XM-220 by
adding four additional epoxy-sealed relays. The XM-220
controls the Expansion Relay module by extending to it the
same logic and functional controls as the XM-220 module’s
on-board relay.