Rockwell Automation 1440-SPD02-01RB XM-220 Dual Speed Module - Manual (Page 40)

Publication GMSI10-UM004B-EN-P - May 2010
32 Installing the XM-220 Dual Speed Module
Figure 2.21 Magnetic Pickup to Channel 1 Wiring
IMPORTANT
An internal isolated constant current (0.5mA) supply is
provided to detect a cable or transducer fault (short). This
current is enabled with the Enable Bias Current
parameter. Refer to Channel Tachometer Parameters on
page 47.
Signal Common
Channel 1 Input Signal
Shield
16
0
37
Cable shield not
connected at this end
TYPICAL WIRING FOR MAGNETIC PICKUP SENSOR
TO XM-220 DUAL SPEED MODULE CHANNEL 1