Rockwell Automation 1440-SPD02-01RB XM-220 Dual Speed Module - Manual (Page 13)

5 Publication GMSI10-UM004B-EN-P - May 2010
Chapter
2
Installing the XM-220 Dual Speed Module
This chapter discusses how to install and wire the XM-220 Dual Speed
module. It also describes the module indicators and the basic operation of the
module.
For information about See page
XM Installation Requirements 6
Mounting the Terminal Base Unit 13
Connecting Wiring for Your Module 17
Mounting the Module 39
Module Indicators 40
Basic Operations 43
ATTENTION
Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2
Industrial environment, in overvoltage Category II applications
(as defined in IED publication 60664–1), at altitudes up to 2000
meters without derating.
This equipment is supplied as “open type” equipment. It must be
mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present, and
appropriately designed to prevent personal injury resulting from
accessibility to live parts. The interior of the enclosure must be
accessible only by the use of a tool. Subsequent sections of this
publication may contain additional information regarding specific
enclosure type ratings that are required to comply with certain
product safety certifications.
See NEMA Standards publication 250 and IEC publication
60529, as applicable, for explanations of the degrees of
protection provided by different types of enclosures.