AJA FS1 - Manual (Page 15)

1
1
Chapter 2:
Controls and Indicators
2
Controls and Indicators
When installing the AJA FS1 chassis, you’ll make media cable connections to a
variety of equipment. After installation, the front panel indicators will be useful in
monitoring what is happening on the system as well as troubleshooting problems
that can occur. Becoming familiar with the FS1 front and rear panels will simplify
installation, setup, and operation of the system. Use of the Web browser user
interface and Remote Control Panel option are described in a later chapter.
On the following pages are front and rear panel illustrations with notations that
summarize all of the connectors and indicators. Detailed descriptions of each of the
connectors and indicators follow afterward.
Full installation instructions are provided in Chapter 3 later in this manual.
Note: The AJA FS1 should be plugged into 3-prong AC power before you make
connections to other equipment. The AC cords provide a path to ground for
accidental static discharge and protect system equipment. The FS1 has two fully
independent and redundant power supplies; it will operate with one or both AC
power cords plugged into the unit, although fault-tolerance will only exist if both
are connected.
Warning: To meet safety regulations for leakage current, connect the FS1 dual
power supplies to separate branch circuits.
WARNING