AJA FS1 - Manual (Page 32)

24
Configuring the FS1 with a Static IP Address
Networking the
FS1 using the
Factory Default IP If you don’t want to use DHCP to network the FS1 and also don’t want to set your
own static IP address, you can simply use a Default setting to use a factory setting of
10.65.74.65. This might be useful for an application where you directly connect a
laptop or computer to the FS1 and want to get networking quickly. Here are the
steps to set up this method of communication:
1. Use the Select buttons to navigate to parameter “50.1 IP CONFIG”, and
then use the Adjust buttons to select “Default”.
2. Set your laptop or desktop computer Ethernet IP address to 10.m.n.m
(where m is not 65 and n is not 74).
Note: for parameters 50.2,
50.3, and 50.4, you will be
setting IP addresses that
consist of “octets” separated
by a period (i.e., 90.0.180.0).
For these parameters, the
Select button selects the
octet and then the
Adjust
buttons select the desired
number. Pressing Select
again advances to the next
octet. At the final octet, the
address will flash—pressing
Select at that point confirms
the setting.