AJA FS1 - Manual (Page 23)

1
15 FS1 Installation and Operation Manual — Connectors
• 8 channels of analog audio in and out via a DB25 TASCAM-style cable (not
supplied).
• GPI connector: Dual isolated TTL compatible inputs and outputs. Functions of
each are selectable in software.
• 10/100 LAN RJ45 connector.
• SDI video with embedded audio In/Out. There are two input and two output
BNC connectors. The outputs are active all the time, although you must specify
the output format (and thus whether any conversion takes place). SDI 2 can
follow the input (“bypass”)—see description on the following page.
• Component YPbPr/RGB Video, 3 BNCs for input, and 3 BNCs for output.
Component can follow the input (“bypass”)—see the description on the
following page.
• S-Video In/Out (Y/C), one 4-pin mini-DIN for input, and one 4-pin mini-DIN
for output—see the description on the following page.
• Composite NTSC/PAL Video In/Out, 1 BNC for input, and 1 BNC for
output—see the description on the following page.
• Reference Video (looping), 2 BNCs
• RS-422: DE-9 Reserved for future use.
Each of these groups of connectors are discussed on the following pages.
Connector
Descriptions 8 Channel AES/EBU Audio Inputs And
Outputs
One BNC is provided for each of four pairs of
channels, both on the input and output: 1/2, 3/4,
5/6, and 7/8.
AES/EBU signals are handled by the FS1
internally as 24-bit digital.
Analog 8 Channel Audio
The two DB25 connectors, one for input and one for
output, support a TASCAM-style cable snake for
balanced 8-channel audio. Analog audio signals are
converted internally to 24-bit digital Audio Inputs
And Outputs
RS-422 Port
This DE-9 connector is reserved for future use.