AJA FS1 - Manual (Page 69)

1
61 FS1 Installation and Operation Manual — 50.1 IP Config
50.1 IP Config
This parameter determines the type of TCP/IP network configuration used by the
FS1. (Networking is discussed in Chapter 3, Installation, topic “Network Connection.”
Note: With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—
changes made while in these menus will be saved and activated when the menu is
exited.
50.2 IP Address
This parameter determines the static IP address used by the FS1 for TCP/IP
networking. (Networking is discussed in Chapter 3, “Network Connection.”
Note: For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that
consist of “octets” separated by a period (i.e., 90.0.181.0). When editing these, the
Select button selects the octet and then the Adjust buttons select the desired number.
Pressing Select Up again advances to the next octet. At the final octet, the address will
flash—pressing Select Up at that point confirms the setting.
When these parameters are edited, you can abort the editing process by backing out
(press the Select down arrow button repeatedly until the edit passes the first octet).
You’ll notice that after completing the edit on the last octet, the display will blink—
this is an indication that the edited IP address is about to be saved. You can save the
edited IP address (press the Select arrow up to save) or choose not to save by pressing
the Select arrow down button.
50.1 IP Config Description of Choices
Parameter Adjustments:
DHCP (Default)
Static Addr
Default Addr
Select automatic IP address assignment from DHCP server on LAN.
Note: if the FS1 cannot find a DHCP server to communicate with, it will fail-over to
the static IP address.
Assign a static IP address manually (parameters 50.2, 50.3, and 50.4 will have to
be entered to accomplish this).
Use the factory default static IP address: 10.65.74.65
50.2 IP Address Description of Choices
Parameter Adjustments:
variable Using the adjust buttons, enter an IP address compatible with your LAN (if you have
one). If direct connecting to a computer, enter a legal IP address that you’ll also
enter in the computer’s web browser. This is only needed for Static IP
configurations.
If 50.1 is set to DHCP and there is a DHCP failure, then the IP address is set to
the static IP address. If 50.1 is set to Default Addr, the default static IP address is:
10.65.74.65