AJA FS1 - Manual (Page 95)

1
87 FS1 Installation and Operation Manual — Remote FS1 Control Via a Web
FS1 Web Interface, Network Screen
IP Address Type (50.1)—Use to change the IP address for the FS1. When an IP address is
entered and the Update button is clicked, the FS1 IP address will change and the
browser will display a “redirecting to...” page which should send the browser to the
new IP address entered. (You can also click on a link on the redirect page.)
IP Address (50.2)—Enter an IP address compatible with your LAN (if you have one).
When networking the FS1 to a computer, this is the IP address that you’ll enter in the
computer’s web browser to bring up the FS1’s web interface from its embedded web
server. You must also click the “Update” button to update the FS1 with the IP address
entered here.
Netmask (50.3)—Enter a subnet mask compatible with your LAN (if you have one). You
must also click the “Update IP Address” button to update the FS1 with the changed
information entered here.
Default Gateway (50.4)—Enter the IP address for your LAN’s gateway/router (if you have
one). You must also click the “Update IP Address” button to update the FS1 with the
changed information entered here.
Update Network Settings—Pressing this button requests the FS1 to update its IP
information with that entered on this screen.
DHCP (default)
Default Addr
Static Addr
Select automatic IP address assignment from DHCP server on LAN
Note: if the LAN DHCP server fails to grant an IP address, the FS1 will default to using
the static address (factory default is 192.168.0.2)
Use the factory default IP address: 10.65.74.65
Assign a static IP address manually (parameters 50.2, 50.3, and 50.4 will have to
be entered to accomplish this).