2 snmp trap destination 1, 3 snmp trap port 1, 4 snmp trap destination 2 – AJA FS1 User Manual
Page 72
64
51.2 SNMP Trap Destination 1
This parameter determines the SNMP destination IP address where trap messages
issued by the FS1 will be sent.
When the SNMP Trap Destination IP addresses are edited, you can abort the
editing process by backing out (press the Select down arrow button repeatedly until
the edit passes the first octet). You’ll notice that after completing the edit on the last
octet, the display will blink—this is an indication that the edited IP address is about
to be saved. You can save the edited IP address (press the Select arrow up to save) or
choose note to save by pressing the Select arrow down button.
51.3 SNMP Trap Port 1
This parameter determines the SNMP Port used for sending destination #1 trap
messages. UDP port 162 is the default used for SNMP trap messages. However, if
this port is being used by another protocol or service, you can change the setting by
modifying this parameter.
Note:
The SNMP Trap Port number does not blink when changed (as does the
Trap Destination IP address); if you change the Port number and exit the parameter
(moving to another parameter), the port will change immediately as edited.
51.4 SNMP Trap Destination 2
This parameter determines the secondary SNMP destination IP address where trap
messages issued by the FS1 will be sent (if desired).
51.2 SNMP Trap Dest 1
Description of Choices
Parameter Adjustments:
variable
Using the adjust buttons, enter the IP address of the destination where SNMP
command messages (called “traps”) will be sent. This is usually an SNMP client
somewhere on your LAN.
Default: 192.168.0.3
51.3 SNMP Trap Port 1
Description of Choices
Parameter Adjustments:
variable
Using the adjust buttons, select a UDP port for sending FS1 trap messages.
Default: 162
51.4 SNMP Trap Dest 2
Description of Choices
Parameter Adjustments:
variable
Using the adjust buttons, enter the IP address of the destination where SNMP
command messages (called “traps”) will be sent. This is usually an SNMP client
somewhere on your LAN.
Default: 192.168.0.3