AJA FS1 - Manual (Page 19)

1
11 FS1 Installation and Operation Manual — Front Panel
Holding down both the Adjust (up) and Adjust (down) buttons—at the same time —
will set that parameter back to its factory default value.
For some parameters, once a parameter is selected the first Adjust button pressed
begins the editing. The top Select button then can be used to choose the position (left
to right) within the parameter being edited.
Holding down both the Select (up) and Select (down) buttons—at the same time —
will return the front panel menu to parameter 1.1 (Output Format). If you are editing
an octet, string or other parameter at the time that requires a commit action (like
editing an IP address that’s blinking) and you press both Select buttons, then the edit
will terminate (i.e. not take affect and not be saved). On the other hand, if you are
editing menu items that should take affect as they are edited (e.g. procamp gain), then
the edited value will directly take affect.
Note: Parameter displays and adjustment choices and values are described in detail
in Chapter 4.
Remote Control Pressing the Remote button once results in a display showing how the FS1 is being
controlled. Pressing the button again cycles the display through all the control options
possible:
LOCAL+REMOTE: Control is from the panel buttons, a web browser, or remote
panel (VTECS). The Remote button will glow white.
REMOTE ONLY: Control of the FS1 is from a web browser on a network attached
computer or a remote control panel via the VTECS protocol (except for the
remote control function). The Remote button will glow red.
LOCAL ONLY: FS1 control is only allowed from the front panel buttons (except for
the remote control function). The Remote button will glow green.
Indicator
Descriptions Indicators on the front panel are multi-state LEDs that illuminate when a condition is
present. The following indicators are conveniently arranged in groups to show specific
subjects; each are also discussed on the following pages.
• Activity LEDs
• Power and Status LEDs
Activity Indicators
HD In—Shows that an active HD signal is detected at the previously selected input.
SD In—Shows that an active SD signal is detected at the previously selected input.
HD Out—Shows that an HD signal is being output.
SD Out—Shows that an SD signal is being output.
Aux—This LED will be ON whenever a GPI input trigger is active—if that GPI
affects the internal state of the FS1. If the associated GPI In parameter ('36.1 GPI
In 1 Response' or'36.2 GPI In 2 Response') is set to No action, then the LED will
stay OFF.