AJA FS1 - Manual (Page 96)

88
Available FS1 s- Click to Refresh—All of the FS1 devices present on the same local LAN
as the current FS1 are listed below this heading (see note below). The serial numbers
of all FS1s on the LAN, or their defined “System Names” (see parameter 50.5) are
listed—and clicking on any of these will bring up the Status screen of that FS1.
Note: the FS1 you control may be running a different software version so screens
may look different. As a rule, it’s wise to have all your FS1 devices running the most
current software and the same version. Also, without a properly configured default
gateway (whether you have a router/gateway or not), the discovery feature “Available
FS1s—Click to Refresh” on the Network page may not work.
Below the FS1s listed are “Other” AJA devices. Items that may appear here include
AJA Ki Pro recorders and AJA KUMO routers.
Note: AJA devices shown are cached and may not reflect the realtime state of all
devices on the LAN. As FS1s and other AJA devices are added or removed from the
network they may take awhile to appear in the listing. If, at anytime you want a current
view of the network (clearing the cache and showing the realtime state), then press
theControl key on your keyboard while clicking the Available FS1s—Click to Refresh
link.
SNMP Screen This screen contains all of the information required to set up SNMP messaging to the
FS1.
FS1 Web Interface, SNMP Screen
SNMP Disabled, Enable 1 or Enable Both (51.1)—Select Enable 1 if you want the FS1
to issue trap messages to the defined trap 1 destination. To issue trap messages to
both Trap 1 and Trap destinations, Select Enable Both. Select Disabled (default)
when you don’t want the FS1 to issue trap messages.
Trap Receivers (51.2 to 51.5)—Enter the IP address of the destination where SNMP
command messages (called “traps”) will be sent (default is 191.168.0.3). This is
usually an SNMP client (“NMS” or Network Management System) somewhere on
your LAN. You must also click the “Update” submit button to update the FS1 with
the IP address entered here. A Port number for the TCP/IP port to be used for trap