AJA FS1 - Manual (Page 45)

1
37 FS1 Installation and Operation Manual — 2.12 Audio Map Ch2
Note: If parameter 4.5 Audio Follow Video is set to ON, then Audio Map Ch1
selection is independently kept for each separate input: SDI 1, SDI 2, Composite, S-
Video, and Component. If Audio Follow Video is set to OFF, then another Audio Map
Ch1 selection is used. This note applies to Parameters 2.11 through 2.18.
2.12 Audio Map Ch2
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 2. Possible choices are the same as
parameter 2.11. Default = AES Ch 2.
2.13 Audio Map Ch3
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 3. Possible choices are the same as
parameter 2.11. Default = AES Ch 3.
2.14 Audio Map Ch4
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 4. Possible choices are the same as
parameter 2.11. Default = AES Ch 4.
2.15 Audio Map Ch5
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 5. Possible choices are the same as
parameter 2.11. Default = AES Ch 5.
2.16 Audio Map Ch6
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 6. Possible choices are the same as
parameter 2.11. Default = AES Ch 6.
2.17 Audio Map Ch7
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 7. Possible choices are the same as
parameter 2.11. Default = AES Ch 7.
2.18 Audio Map Ch8
This parameter is used with parameter 2.2—when “Channel Map” is selected—to
specify the source of the audio output on channel 8. Possible choices are the same as
parameter 2.11. Default = AES Ch 8.