AJA FS1 - Manual (Page 42)

34
Notes:
1. Bypass applies to all Analog outputs (Component, Composite, and S-Video).
When 1.3 Component Out is set to 'Bypass', Input signal format is 525i/59.94,
and 5.2 SD Aspect Ratio is set to anything other than 'Off', the Composite Out
and S-Video Outputs will also bypass the Aspect-Ratio-Converter.
2. Setting parameter 1.3 Component Out to “Bypass” causes Composite Output to
bypass aspect ratio conversion (parameter 5.3).
3. As in 1.2 SDI2 Out, Bypass mode is not offered in these cases (3:2 Pulldown):
1080pSF/23.98 Input / 1080i/59.94 Output
1080pSF/23.98 Input / 525i/59.94 Output
1080pSF/24 Input / 1080i/60 Output
In these cases, Bypass mode behaves like Normal mode—the output is the same
format as the main SDI1 output.
2.1 Video Input
This parameter performs input video source selection for the FS1. Multiple input
sources may be present at all the connectors on the FS1 rear panel, but the active
input source routed through the FS1 will be the one selected here.
Notes:
1. Changing the Video Input selection automatically selects new values for Proc
Amp parameters (10.1 through 10.5). Each video source remembers its own
Proc Amp settings. This is referred to as Source Memory.
2. If 4.5 Audio Follow Video is set to On, then changing the Video Input selection
will also automatically select new values for all audio parameters associated
with Audio Follow Video (see the list provided in the description of parameter
4.5 Audio Follow Video). Audio Source Memory is enabled only when 4.5
Audio Follow Video is set to On.
2.1 Video Input Description of Choices
Parameter Adjustments:
SDI 1 (Default)
SDI 2
Composite
S-Video
Component
Select SDI 1 connector as the input source
Select SDI 2 connector as the input source
Select the Composite connector as the input source
Select the S-Video connector as the input source
Select the Component connector as the input source