1 individual key functions – Metrohm 774 Oven Sample Processor User Manual
Page 51
5.2 The keyboard
774 Oven Sample Processor, Instructions for use
45
5.2.1 Individual key functions
Key
Normal state
Editing
CONFIG
Opens the configuration Menu
• The <Config> key opens the
selection menu for the con-
figuration of the sample
changer.
• The settings in the Configura-
tion Menu remain constant un-
til they are changed or the
working memory (RAM) is re-
initialized.
Select configuration settings
• When the Configuration Menu
is open, pressing the
<CONFIG> key displays the
next menu line.
• After the last line is displayed,
the first one follows.
• <Quit> exits the menu.
PARAM
Open the parameter menu
• The <Param> key opens the
selection menu for the
changer and dosing settings.
•
All settings that are set in the
Parameter Menu belong to a
method and will be saved with
the method. These parame-
ters are method-specific.
•
The settings in the Parameter
Menu also apply to Manual
mode.
Select method parameters
• When the Parameter Menu is
open, pressing the
<PARAM> key displays the
next menu line.
• After the last line is displayed,
the first one follows.
•
<Quit> exits the menu.
USER
METHOD
Open the user method menu
•
The <User Method> key
opens the selection menu for
the loading, saving and dele-
tion of user-defined methods.
Select method functions
• When the User Method Menu
is open, pressing the <USER
METHOD> key displays the
next menu line.
• After the last line is displayed,
the first one follows.
• <QUIT> exits the menu.
HOME
Bring lift to zero-position
•
The <Home> key runs the lift
of the active tower to the zero-
position (0 mm), i.e. to the
upper stop.
Select the first line of a menu
•
With the <Home> key, the
first line in a menu or a se-
quence can be accessed.
•
Any data that has been altered
in a menu or command line is
not carried over. See
<ENTER> key.