Document Outline

• Table of Contents
• Index
• Chapter1.pdf
  • C H A P T E R 1 Introduction
    • Warnings and FCC Compliance
      • Communications Disclaimer
      • FCC Part 68 Compliance (applies only to Landline Units)
      • FCC Part 15 Compliance
      • GSM/GPRS Modem Information
    • Installation and Configuration
    • Product Warranty
      • New Product Warranty
      • Out-of-Warranty Product Repairs
      • Troubleshooting Fee
      • Shipping
• Chapter2.pdf
  • C H A P T E R 2 System Overview
    • ADS RainAlert II Monitor
      • Printed Circuit Board
        • Digital Signal Processor
        • Digital Counter
        • Communications
        • Voltage Regulator
      • Communications
      • Connectors
      • Power
    • Tipping Bucket
• Chapter3.pdf
  • C H A P T E R 3 Hardware Installation
    • Investigating Site Characteristics
    • Gathering the Parts and Supplies
    • Gathering the Tools and Equipment
    • Installing the Tipping Bucket
    • Calibrating the Tipping Bucket
    • Installing the RainAlert II
      • Mounting the Monitor to a Wall
      • Mounting the Monitor on the Base Plate
    • Connecting the Tipping Bucket to the Monitor
• Chapter4.pdf
  • C H A P T E R 4 Communication
    • Setting Up Wireless Communication
      • Installing a Mini-wing or Slim Antenna
      • Installing a Magnetic Whip Antenna
      • Modifying the RainAlert II Monitor to Support an External Antenna
      • Installing the SIM Card
    • Providing Telephone Service
      • Running the Telephone Cable Between the Monitor and Service Locations
      • Mounting the Lightning Protection Module
      • Preparing the Telephone Cable
      • Wiring the Telephone Cable to the Monitor
      • Wiring the Telephone Cable to the Lightning Protection Module
      • Wiring the Lightning Protection Module to the Network Interface Box
    • Connecting to the Monitor in the Field
• Chapter5.pdf
  • C H A P T E R 5 Configuration and Activation
    • Configuring the Monitor Location
      • Launching the Profile Software
      • Creating a Monitor Location
      • Selecting and Editing Devices
        • Editing the Rain Device
        • Editing the Notification Device
        • Editing the RSSI Device
    • Setting the Communication Parameters
    • Activating the Monitor
    • Configuring the Power Savings Parameters
    • Running Diagnostics on the Rain Device
    • Collecting Data from the Monitor
    • Upgrading the Monitor Firmware
    • Viewing Diagnostic and Data Logs
• Chapter6.pdf
  • C H A P T E R 6 Maintenance and Troubleshooting
    • Maintaining the System Components
      • Gathering Replacement Parts and Supplies
      • Inspecting the Monitor
        • Confirming the Monitor
        • Checking the Monitor Battery Pack Voltage
          • Replacing the Monitor Battery Pack
      • Checking the Tipping Bucket
      • Checking Communication Devices
    • Troubleshooting
      • General Monitor Problems
      • General Communication Problems
      • General Tipping Bucket Problems
• AppendixA.pdf
  • A P P E N D I X A Specifications
    • ADS RainAlert II Monitor (p/n 6000-RAW/RAL)
    • Printed Circuit Board (ADS p/n 6000-0001)
    • Tipping Buckets (ADS p/n 103202A/B/C/D)
    • Lightning Protection Module (ADS p/n 103313)
• AppendixB.pdf
  • A P P E N D I X B Part Numbers
• RainAlertIIMasterA2.pdf
  • Table of Contents
  • Index