ADS Environmental Services Spider QR 775010 A0 - Manual (Page 23)

ADS Environmental Services ADS Spider User Manual
Page 21
The following table lists the part numbers for the antennas, adapters,
and extension cables:
Part Part Number Comments
Magnetic Mount
Antenna
3800-0128 8-foot cable included,
requires P/N 507482
adapter to fit FME
connector
Wing Antenna 507385 8-foot cable included,
no adapter required
SMA/F to FME/F
Adapter
507482
10 ’ FME/M to
FME/F Extension
Cable
3800-0166-0
25
’
FME/M to
FME/F Extension
Cable
3800-0166-25
50
’
FME/M to
FME/F Extension
Cable
3800-0166-50
When attaching the antenna or extension cables, hand-tighten only.
Using tools to tighten antenna connectors may damage them, voiding
the warranty. If connections are outdoors, always seal the connection
completely using rubber or silicone stretch tape or sealing mastic. Do
not crimp or clamp coaxial cables, as any change in circular cable
geometry will result in signal loss and reduced performance.
INSTALLATION WARNING!! When routing antenna cables inside
areas with control equipment, do not lay the Spider antenna cable
close to or parallel with any other cabling! Keep the antenna cable at
least 6 inches away from other conductors, and cross at right angles
only when required. Conduit is not required unless physical
protection is necessary.
Power
The Spider can receive power either from an AC charger with a
backup battery or from a solar panel and backup battery.