B&G H2000 Pilot *DISCONTINUED* - Manual (Page 107)

HB-0845-06 107
3. Check for any large steel structures nearby, that
may cause additional, erratic deviations.
4. Scroll to the MISC menu and select HALCYON
on the top display. GYRO will be displayed in the
top data line if a Halcyon Gyro Stabilised
Compass is connected.
5. Press scroll down until the lower text shows
‘CALIBRATE’ press the ENTER key
6. Press scroll down until the lower text shows
CALIBRATE, press the ENTER key, and scroll
down to CAL VAL 1, press enter and START
will be displayed with ‘0’ as a default value
7. Press enter and the ‘0’ starts to flash. Use the
scroll up key to change the value to ‘1’.
8. Press the Enter key. The display now shows
000
°
.
9. At a speed not exceeding five knots, turn the boat
through 360
°
at a rate not greater than 2-3
°
per
second. The display will show the amount of turn
completed so far. Continue to turn the boat until
the display shows PASS or FAIL. If FAIL is
displayed you must re-calibrate your compass.
Notes
• The compass calibration swing can be aborted at any
time. To do this press the Enter key once. Next press the
Scroll Down key and change the value from ‘1’ to ‘0’.
• You can re-calibrate at any time by following the above
procedures.
If you have any constant error in your heading, you can
correct for this:
NAVIGATE
→ → → →
HEADING, CALBRATE
→ → → →
CAL VAL1