B&G H2000 Pilot *DISCONTINUED* - Manual (Page 151)

HB-0845-06 151
Bearing to Waypoint* Course Over Ground*
Speed Over Ground* True Wind Direction
Note
• Functions marked with an * are NMEA Functions and
are available only when a suitable Position Fixer is
interfaced with the system.
5.6.3 Function Selection - Remote Push-Button
If a remote push-button is connected to a 40/40 display any
one of the 14 pre-set functions may be selected by pressing
and holding down the associated button. The display will
then cycle through the functions. When the required
function is displayed, release the button.
If the button is held down too long and the required function
is missed, press and hold down the button again. The
display will then cycle through the functions in reverse
order. When the required function is displayed, release the
button.
5.6.4 Function Selection - FFD
An alternative to using a dedicated remote push-button, is to
control the 40/40 using any one of the standard FFDs on the
system. Any 40/40 can be controlled from any FFD.
To change the function shown on a 40/40 using an FFD,
proceed as follows:
1. At the FFD, press and hold down the Page Key
for at least 3 seconds. The FFD display will
change to show the function displayed on the
40/40 together with the display number. The
selected display will start to flash.
2. Using the Scroll Down Key cycle through the
40/40 numbers and select the required display
number.