B&G H2000 Pilot *DISCONTINUED* - Manual (Page 42)

h2000 User Manual
42 HB-0845-06
WARNING
All alarms in the system will remain OFF until the
values are reset or the individual alarms are turned on
again.
2.5.6 Selective Alarm Display
When an alarm condition arises all FFDs in the system flash
the alarm function on the bottom half of their displays.
Individual FFDs can be set to ignore alarm messages.
The procedure for Selective Alarm Display is as follows:
1. Press the Page key.
2. Scroll up to CNFG DSP, then press Enter.
3. Scroll up to SHOW ALM, then press Enter.
4. Scroll to NO, then press Enter.
5. Press the Page key to return to normal view.
This display is now set to ignore any alarm function.
2.6 TRIP FUNCTIONS
The h2000 provides three trip functions: Timer (count-up
and count-down), Trip Log and Dead Reckoning. The
functions can be reset and restarted as required, e.g. for
keeping a separate log of elapsed time and distance run for a
given passage.
When any trip function is started, all other trip functions
which have been reset start simultaneously, except when the
timer countdown is started. Under this condition, the other
functions start, again if previously reset, when the
countdown reaches zero. This is designed for the beginning
of races, so that you have DR, log and timer running
without pressing buttons during the intense moments of the
start itself.
When a trip function is on the display, the two right hand
characters show the status of the display.