B&G H2000 Pilot *DISCONTINUED* - Manual (Page 93)

HB-0845-06 93
1 = Use Speed Over Ground
3.2.13 Pulse2 Boat Speed Input
The h2000 is able to display boat speed readings from a
secondary boat speed sensor connected to the main
processor. The function PULSE2 can be renamed by
selecting one of the pre-defined functions. This is done by
entering the corresponding number under:
SPEED
→
PULSE2, CALBRATE
→ → → →
CAL VAL 1
CAL VAL 1
Setting
Function Text
Shown
Notes
0 PULSE2
Default setting. The display will
show the input in Hz if present.
1 STBD BS
The secondary boat speed sensor
is declared as STBD under the
SPEED menu. The primary boat
speed sensor is declared as PORT
in the SPEED menu.
2 PORT BS
The secondary boat speed sensor
is declared as PORT under the
SPEED menu. The primary boat
speed sensor is declared as STBD
in the SPEED menu.
3 BOAT SPD
The primary boat speed sensor is
completely replaced by the
secondary boat speed sensor.
Additionally, it is possible to configure the h2000 to use an
external speed source and disable the boat speed sensor
inputs connected to the main processor. This is done by
entering the corresponding number under:
SPEED
→
PULSE2, CALBRATE
→ → → →
CAL VAL 2