B&G H2000 Pilot *DISCONTINUED* - Manual (Page 176)

h2000 User Manual
176 HB-0845-06
00,19.8H(CR) Heel angle
01, 8.35(CR) Boatspeed
r00,1234(CR)
r01,45.88(CR)
If no data is available for a selected channel the text ‘OFF’
will be substituted.
5.15.7 Input Remote Channel Data and Text
####
IR,nn,a...a,c...c,d...d(CR)
nn = Remote channel number (00 to 31). This must be
allocated to the REMOTE 0 - 9 function by adjusting its
CAL VAL3 or using the
#
RC,nn,cc(CR) command.
EXTERNAL
→
REMOTE 0, CALBRATE
→ → → →
CAL VAL3(CHAN NO)
or
using the
####
RC,nn,cc(CR) command.
a...a = Remote channel data which will be output on the
FFD or 20/20CD digits.
c...c = Text to be displayed on the FFD or 20/20CD. Up to
16 characters may be sent but only 10 are used.
d...d = Page Text, ignored (was used in 290 & 390 Systems)
If only data is to be input the command may be terminated with a
(CR) after the data parameter as follows:
####
IR,nn,a...a(CR)
Note
• This command has no effect on remote channels
currently assigned to NMEA functions.
5.15.8 Automatic Output of Basic Data
Basic data consists of the values obtained from the boat
speed, wind speed, wind angle and heading sensors without
damping or calibration.
####
OB,s(CR)