B&G H2000 Pilot *DISCONTINUED* - Manual (Page 194)

h2000 User Manual
194 HB-0845-06
5.15.31 h2000 General Purpose Input Value
####
IV,nnn,mmm,fff,xx.xx,tttttttttt(CR)
nnn = node number to which value is to be sent
1
- Depth Board
5 to 8 - Wind Boards
9 to 12 - RS232 or NMEA Board
255 - Broadcast to all Boards
mmm = message type to be used
211
- Calibration Value 1
212 - Calibration Value 2
213 - Calibration Value 3
214 - Calibration Value 4
206 - Damping Value
34 - High Alarm Value
33 - Low Alarm Value
32 - Sector Alarm Value
1 - Data Value
2 - New text for an existing function
fff = function number see Table 14
xx.xx = Value value to be sent, or node number of function
fff if mmm=2
tttttttttt = function text displayed on FFD, 20/20 or 40/40
This is a general purpose command for inputting values to
other nodes.
5.15.32 General Purpose Output Value
####
OV,nnn,mmm,fff,(CR)