Baseline Systems FreeWave Ethernet Radio - Manual (Page 31)

User Manual and Reference Guide
LUM0024AB Rev A
3. In the IP Address field, update the IP address to the address you want to assign to the
transceiver.
4. In the Password field, enter the current administrator password.
Transceivers running firmware version 2.14 or earlier only accept admin as the valid password.
Transceiver's running a later version of firmware accept any password up to 7 characters long.
Discovery Server can only change the basic settings of a transceiver if that transceiver’s
administrator password is seven characters long or less. Any passwords longer than seven
characters are not accepted in Discovery Server. You can use this password limitation to limit
which transceivers can be changed using the Discovery Server application.
5. Click Change to change the settings on the transceiver.
Resetting Transceivers to the Factory Default Settings
To reset a transceiver to the factory default settings, complete the following steps. For a list of factory
defaults, see "Factory Default Settings" on page 101.
1. Access HyperTerminal as described on page 9
2. With the HyperTerminal session open, connect power to the transceiver.
After a few seconds, the following screen display in the HyperTerminal window:
3. Type a Y or a y within 5 seconds (even though the text says 2 seconds) to access the IP setup of
the transceiver.
Any other key exits, allowing the transceiver to complete the boot-up. After entering a Y, a
password prompt displays:
15