Default gateway, Ip address – Baseline Systems FreeWave Ethernet Radio User Manual
Page 48
FGR2-PE Wirelss Data Transceiver
LUM0024AB Rev A
Network Type:
Point-to-Point, Point-to-MultiPoint, or Both
Default Setting:
The factory default setting for the parameter.
Options:
The options to which the parameter can be set.
Description:
A description of what the parameter is and how it applies to the transceiver in
your network.
The parameters are listed in alphabetical order by their Tool Suite field name.
Default Gateway
Web Parameter:
Default Gateway in the LAN Network Interface Configuration section of the IP
Setup page.
Network Type:
Both
Default Setting:
192.168.111.11
Options:
Any valid IP address.
Description:
The IP address of the Gateway's VLAN. This parameter is typically set by a
network administrator.
Note: Putting multiple devices on the network with the same IP address can
cause the entire network to crash.
IP Address
Web Parameter:
IP Address in the LAN Network Interface Configuration section of the IP
Setup page.
Network Type:
Both
Default Setting:
192.168.111.100
Options:
Any valid IP address.
Description:
The IP address assigned to the transceiver. Assign an unique IP address to
each transceiver in your network. The IP addresses must be in the proper
subnet.
It is also possible to have a transparent bridge with an IP address of
255.255.255.255, but serial port functionality, the Security features, and
access to the configuration Web pages is lost.
This field is hidden in the configuration Web page when Global Changes are
enabled. For more information about making global changes, see "Using the
MultiPoint Gateway to Change All Connected Transceivers" on page 21.
Note: Putting multiple devices on the network with the same IP address can cause the
whole network to crash.
When the VLAN Mode parameter is set to Tagged or Untagged, this IP information is assigned to the
Management portion of the transceiver (Setup pages, SNMP, Discovery Server). Any communication with the
transceiver's Setup pages, SNMP, or changes made using the Discovery Server need to be addressed to this
IP address and tagged with the Management VLAN ID.
32