Baseline Systems FreeWave Ethernet Radio - Manual (Page 65)

User Manual and Reference Guide
LUM0024AB Rev A
UDP Power Up Port
Web Parameter Power UP Dest. IP & Port in the UDP Settings section of the Serial Setup
page.
Network Type: Both
Default Setting: 0000
Options: Any valid port number between 0 and 65535.
Description: The port used if the serial port is set to UDP mode.
In the configuration Web pages, enter the IP address in the field to the left of
the colon. Enter the port number in the field to the right of the colon.
UDP/Multicast Enable
Web Parameter: Mode in the Terminal Server Configuration section of the Serial Setup page.
Network Type: Both
Default Setting: Disabled
Options: Disabled, Enabled
Description: Enables the transceiver as a UDP terminal server using the port number entered in the
UDP Local Port parameter or as a multicast if the Use as Multicast parameter is also
enabled.
If using as a UDP terminal server, the port number entered in the UDP Local Port
parameter is the UDP port that the transceiver listens to for requests. After a request
comes into that port, the transceiver sends any incoming serial data to the IP address of
the requesting device. The transceiver continues doing so until a new device makes a
request on that UDP port. The transceiver always sends the serial data to the address of
the last successful requesting device.
A multicast is a one-to-many connection from the MultiPoint Gateway’s serial port to the
interested MultiPoint Repeaters’ and/or Endpoints’ serial ports.
49