Baseline Systems FreeWave Ethernet Radio - Manual (Page 35)

User Manual and Reference Guide
LUM0024AB Rev A
Accessing Configuration Web Pages
Each Plus-style transceiver has a built in Web interface that you can use to program its settings. To access
the Web interface, you must have a Web browser installed on your computer.
1. Plug the radio into either a computer or a switch/router using an RJ45 cable.
2. Open a Web browser such as Internet Explorer, Netscape, or Firefox and type the IP address of
the radio into the address bar.
For example, to access a radio with an IP address of 192.168.111.90, type http://192.168.111.100
into the address bar of the web browser.
A static IP address on the same subnet may need to be assigned to the router/switch and/or the
computer to access the transceiver. For more information, see "Changing the Computer IP
Address in Windows" on page 121. The default IP address from the factory is 192.168.111.100.
A prompt for a user name and password displays.
3. Enter the user name and password to access the transceiver.
The default user name for the administrator login is admin, the password is admin. The
administrator login has full permission to change all settings on the transceiver, including
upgrading firmware.
The default user name for the guest login is guest, the password is guest. The guest login can
view the settings. When logged in as a guest, you can see the Status, IP Setup, Serial Gateway
Setup, and Radio Setup pages. When logged in as a guest, you cannot save any changes, cannot
see the Security or Tools pages, and cannot reboot the transceiver.
Navigating the Web Pages
The configuration Web pages group the parameters into pages and provides the navigation features described
below.
The Pages menu displays on the left side of all pages. Click the items in this list to
navigate to the different configuration pages available for the transceiver. The currently
selected page is highlighted in teal.
Below the Pages List is the Reboot button. Click this button to force the transceiver to
reboot.
When making changes to the transceiver settings, click the Save/Apply button before
navigating away from a page or rebooting the transceiver to save your changes. No
changes take effect until you click Save/Apply.
When the changes have been successfully saved and applied,
the message Change Succeeded displays under the Reboot
button.
19